Name: IsoPac A
Dimensions: 7' wide x 9' deep x 6.5' tall
Parts Included: (1) A5-7 - 7-section CSP
(3) S5-2L - 4' W x 5.5' H SORBER baffle (rear)
(7) AX12 - 12" height extenders
(1) STC5L - 2' W x 5.5' D center lid section
(1) STC512L - 12" W x 5.5' D center lid section
(2) STS5L - 2' W x 5.5' D side lid section
(7) S2L - 22" W x 2' H SORBER baffle
(1) Fan - 6", 2-speed, low noise fan
Amount of Sound Reduction: 50-60%
IsoPac A has seven ClearSonic panels and AX12 extenders in the front, and three S5-2 SORBER baffles in the rear. Seven S2 SORBER baffles are attached to the inside lower portion of the acrylic panels. The clear panels are a total of 6.5' tall, and the S5-2 baffles are 5.5' tall, so there is a foot of open space around the rear of the booth allowing for air exchange.The STC512 twelve inch wide SORBER Lid baffle is added to the standard 3-section lid to yield 7'W x 5.5'D of lid coverage. IsoPac A includes two lid support bars for maximum stability.
If reflections off the front shields during recording are a problem, a few S2 SORBER baffles can be Velcroed to the offending shields. Attach them at the same height of the mic.
ClearSonic IsoPacs are our most popular isolation packages, and can easily be modified to fit your specific needs.
IsoPacs A, B, E, F, G, and H feature the ClearSonic Lid System, that helps reduce the amount of sound that would normally escape upwards. The Lid is especially helpful if you have a room with high, hard ceilings. IsoPacs C and D are for applications where the lid is not necessary, but still feature SORBER absorption baffles to control the reflected sound. IsoPacs E through H can be used for a variety of applications including vocal and voice-over work.
ClearSonic Panels are a reflective sound barrier but do not absorb sound while SORBER is a great sound absorber but not a great barrier. Therefore, our most effective systems, such as MegaPac, use ClearSonic Panels all the way around the perimeter. Having ClearSonic Panels with Height Extenders in the back also greatly reduces the size of the open area where sound can escape. Because of this, MegaPac and similar booths will reduce sound leakage up to 70% while systems with only SORBER in the back will reduce leakage around 50%. The rear panels are usually not attached to the front panels. They simply butt together or overlap a bit. An access "door" panel is created at the overlap location.