Audio Technica PRO 35 Cardioid Condenser Clip-on Instrument Microphone
Designed for sax, toms, brass and percussion, the PRO 35 excels in high-SPL applications and is ideal for active stage performances. Its extended frequency response captures subtle nuances of the performance. The included UniMountå¨ clip permits accurate positioning and provides shock resistance while protecting the element. The microphoneåÂÌ_s cardioid polar pattern reduces pickup of sounds from the sides and rear, improving isolation of the desired sound source.
* UniMountå¨ clip permits accurate positioning, provides shock resistance and protects element.
* Cardioid polar pattern reduces pickup of sounds from the sides and rear, improving isolation of desired sound source.
* Extended frequency response captures subtle nuances of the performance.
* 6' (1.8 m) cable permanently attached to microphone.
ELEMENT: Fixed-charge back plate, permanently polarized condenser
POLAR PATTERN: Cardioid
FREQUENCY RESPONSE: 50-15,000 Hz
LOW FREQUENCY ROLL-OFF: 80 Hz, 18 dB/octave
OPEN CIRCUIT SENSITIVITY: -45 dB (5.6 mV) re 1V at 1 Pa
IMPEDANCE: 250 ohms
MAXIMUM INPUT SOUND LEVEL: 145 dB SPL, 1 kHz at 1% T.H.D.
DYNAMIC RANGE (typical): 115 dB, 1 kHz at Max SPL
SIGNAL-TO-NOISE RATIO: 64 dB, 1 kHz at 1 Pa
PHANTOM POWER REQUIREMENTS: 11-52V DC, 2 mA typical
SWITCH: Flat, roll-off
WEIGHT (MICROPHONE): 0.3 oz (8 g)
WEIGHT (POWER MODULE): 2.9 oz (81 g)
DIMENSIONS (MICROPHONE): 0.98" (25.0 mm) long, 0.40" (10.2 mm) diameter
DIMENSIONS (POWER MODULE): 3.66" (92.9 mm) long, 0.74" (18.9 mm) diameter
OUTPUT CONNECTOR (POWER MODULE): Integral 3-pin XLRM-type
CABLE: 6.0' (1.8 m) long (permanently attached to microphone), 0.10" (2.6 mm) diameter, 2-conductor, shielded cable with TA3F-type connector
ACCESSORIES FURNISHED: AT8418 UniMountå¨ microphone instrument mount; AT8538 power module; soft protective pouch
AUDIO-TECHNICA CASE STYLE: M12